SAPOA’s new method for measuring floor areas garners support

While the SA Property Owners’ Association’s (SAPOA) new method for measuring floor areas was approved for use in August 2005, it is only in the last two years that Excellerate Facilities Management (EFM) has seen a marked increase in interest among commercial property landlords to amend  records accordingly.
Explains Sean Liebenberg, new business executive for EFM: “The new method was introduced as a far more accurate means of measuring floor areas for office, retail and industrial space and SAPOA recommends its use for both existing and new buildings. As members of SAPOA and as intended, both EFM and our clients are embracing this new method in order to achieve national uniformity in regard to the measurement of rentable area.”
He says it is interesting to note that in general, landlords benefitted from the fact that the remote common areas (such as entrance foyers, plant and service rooms) have now been allocated on a proportionate basis to tenants. On the other hand total rentable areas decreased because supplementary common areas, such as stores in office blocks, now come out of the total rentable area of a building and are listed separately and charged at a rate or cost at the landlord’s discretion.
Liebenberg says in the past EFM had to produce measurements with four decimal places in order to balance with property management systems rounding off at three or less decimals. Adoption of the SAPOA recommendation of rounding off to the nearest full square metre eliminates numerous debates with various consultants over minor decimal differences.
“We are now applying the following rules when measuring areas for the various building types. Firstly, in regard to offices, the rentable area comprises the usable area plus the common area. The common area is broken down into two further categories, namely the primary common area on any given floor, and the remote common area such as entrance foyers, plant and service rooms located elsewhere in the building, or on site and not on the given floor. The rentable area excludes a supplementary area that may produce additional revenue (for example storerooms, balconies, terraces, service passages, parking, etc).”
Liebenberg says in EFM’s experience these definitions have made quite substantial changes in comparisons of old to new measurement methods. Remote common areas have increased the rentable area while in turn the supplementary common areas have reduced the rentable area.
“This varies from building to building and in some cases they either even each other out, or increase or decrease the total rentable area - depending on respective sizes and areas. Overall we have noted an increase of between 2.5 to 5 percent in rentable area across office buildings we have re-measured. The challenge for landlords and property managers is how to apply these new rentable areas per tenant into current leases and property management system records. We recommend that SAPOA looks into how remote common areas located in the common site in an office park with varying building sizes are applied.“
In regard to retail space, the rentable area comprises the usable area plus the secondary common area serving only one tenant.  The useable area is the area capable of exclusive occupation by the tenant and is the total area enclosed by the lease line, the demising walls and external walls, whether or not a shop-front is erected behind the lease line.
The common area consists of the primary and secondary common areas. The primary common area comprises all building areas that are not part of the rentable area, and the primary common area is not charged to tenants and includes parking areas. The secondary common area is an area such as an access passage, plant room, toilets, loading docks, etc. Any secondary common area dedicated to serve one tenant becomes rentable.
Comments Liebenberg: “Our challenge now and in the past has been the interpretation of the lease line. SAPOA indicates that this is the notional line determined by the landlord as the maximum extent of the shop-front position separating the shop unit from the primary common area. The actual position of the shop-front behind the notational lease line is not taken into account in the measurement of the usable area.
“Often the lease line, especially with old buildings, is not indicated on any hard copy drawings or historical records. Determining the maximum extent is open to interpretation so we have relied on landlord interpretation and opinion. Applications vary from the inner surface of the glass or shop-front detail to the furthest extent of structural columns protruding into the primary common area and between consecutive shops. Isolated columns and enclosed penetrations are excluded from the usable area irrespective of size, while projections in demising or external walls exceeding 0.25 square metres in the sectional area are also excluded.”
Liebenberg says that columns have created somewhat of an issue as the new method refers to isolated columns and projections in demising walls. However, the text and diagrams in use in the current SAPOA document leave room for differing interpretations. Isolated columns are easy to identify and remove while demising projections could be interpreted differently, either in or out depending on sectional area calculations.
“We suggest having these interpretations and decisions or rules documented and approved by the landlord as the applied rule which can be retrieved and justified should another party challenge the measurement. We have noted an increase in retail rentable areas even with the exclusion of columns and projections in demising walls. A large component of the increase relates to the inclusion of secondary common areas dedicated to one tenant. Quite often the larger retail stores will include service passages, dedicated plant rooms, toilets and loading docks. Again this varies from store to store, but across the board EFM has encountered increases in rentable area between 2.5 and 7 percent,” he says.
In regard to industrial property, the major change with industrial buildings is the classification of the buildings into two categories - single tenant industrial buildings and multi-tenant industrial buildings. In single tenant industrial buildings the rentable area is the entire construction area measured at each covered floor level over the external walls to the external finished surface - without any deductions. In multi-tenant industrial buildings the rentable area comprises the usable area plus the common area. Says Liebenberg: “While we have made adjustments to records for single tenant industrial buildings, in our experience very little has changed regarding multi-tenant industrial buildings. The adjustment in rentable area is quite noticeable for single tenant industrial buildings.
“We believe this project is extremely worthwhile and welcome the new measurement method. In the end the areas will not change immediately for a tenant lease but in the long-term on renewal or negotiation of new leases a definite increase in rentable area and property value will be experienced. As landlords apply this new measurement method  in regard to their portfolios, interpretations will be resolved and in time the SAPOA document can and will be enhanced to reflect these experiences and adjustments,” concludes Liebenberg.

  Comment on this Article

  Please login to post comments

Post to my facebook wall
Characters remaining

    Latest Property News
    • 19 Jun 2018
      In the current market, letting out a property can be a good option as rental demand remains strong, especially in the northern suburbs of Johannesburg. This is according to Chris Renecle, MD of Renprop. However he says that before homeowners let their property out, there are five key points they should make sure are covered before they market the property for rent and sign any lease agreements.
    • 19 Jun 2018
      The Capetonian dream is to live by the ocean with the iconic mountain making an appearance somewhere in the horizon. But, that dream comes with a hefty price tag that many simply cannot afford. But, should you venture some kilometres out of the city centre, entirely new realms of beachside bliss await you …
    • 19 Jun 2018
      Douw Steyn, one of the richest men in the country, recently allowed a rare glimpse into his Fourways Palazzo when it was featured on the SABC lifestyle programme Top Billing - and it is beyond your wildest dreams!
    • 18 Jun 2018
      Many home sellers are motivated to appoint estate agents because they know that the agency will carry the costs of advertising and marketing their property.
    • 18 Jun 2018
      When a property is sold when it has a tenant in occupation, the questions often raised are: “What happens to the tenant if the landlord sells the property?”, and what rights the tenant will have with regards to cancelling the lease or enforcing it, says Sunell Afrika, rentals manager for
    • 18 Jun 2018
      Sellers are often caught off-guard by the expenses incurred in the selling of a property. Just like there is no such thing as a free lunch, there is also no such thing as selling your property without incurring at least some costs.
    • 15 Jun 2018
      The second quarter of 2018 has proven to be the turning point for Midrand’s real estate market, especially the upper end which started to waver towards the end of a tumultuous 2017 with a notable drop in both sales and average selling prices.
    • 15 Jun 2018
      According to data recently released by FNB, the average age of a South African home buyer has increased from 38 to 44 this year. In an attempt to help first-time buyers enter the market sooner, Adrian Goslett, Regional Director and CEO of RE/MAX of Southern Africa, walks us through the steps of saving for your first home.
    Subscribe to the MyProperty Newsletter

    Last Name  
    Email Address  
    Email Frequency
    Share this Page

    For Sale Property
    Rental Property
    More Options
    Connect with us